FAG bearing housings and bearing assemblies have been successfully tested in machinery, factories and other equipment and have stood the test.
FAG bearing housings are usually made of gray iron. Cast steel and nodular graphite iron bearing housings can also be supplied, if necessary. Because bearings are usually lubricated with grease, the grease can be lubricated for the first time after filling for the first time, so most of the bearing housings do not have lubrication holes. However, there is a sign on the bearing seat and drilling holes can be drilled if necessary. In re lubrication, it is necessary to ensure that excess lubricant is spilled.
bearing housings are usually machined to allow bearings to move in them and can be used as non positioning bearings. The positioning bearing configuration can be achieved by inserting the alignment ring, if listed in the form. The positioning ring must be specially ordered. An outer housing without a locating ring; used for non positioning bearings (L) or positioning bearings (F).
General paint coatings are all rough outer surface and shell parts FAG shell (RAL 7031 color, blue and grey) can be all resin, polyurethane, acrylic acid, epoxy resin, chlorinated rubber, cellulose and acid hardening hammer gray enamel paint to cover this. The anti-corrosion of the inner and outer surfaces after processing can be easily removed.
according to operating conditions, contact seals, non contact seals, and their combinations are all available for sealing of bearing housings |
